Toro 30410 Operator's Manual

Also see for Groundsmaster 4000-D: Installation instructions Service manual Service manual Service manual Service manual

Contents

3. When all of the oil has drained, position thewheel so that the plug hole is at the ten or twoo’clock position.4. Place a drain pan under the brake housing onthe other side of the wheel (Figure 59).5. Remove the plug from the bottom of thehousing and allow the oil to drain.6. When all of the oil has drained, install the plugin the housing.7. Add approximately 16 oz (0.5 l) of high qualitySAE 85W-140 gear lube to the planetary fillhole (at the ten or two o’clock position) untilthe level is up to the bottom of the brakehousing check hole. Install the plug.8. Repeat the procedure on the opposite gearassembly.Figure 591. Brake housing 3. Check plug2. Drain plugChanging the Rear AxleLubricantChange the oil initially after the first 200 hoursof operation and every 800 hours of operationthereafter.1. Position the machine on a level surface.2. Clean the area around the 3 drain plugs; 1 oneach end and 1 in the center (Figure 60).3. Remove the check plugs to ease in draining ofthe oil.4. Remove the drain plugs and allow the oil todrain into the pans.Figure 601. Drain plug location5. Clean the area around the drain plug on thebottom of the gear box (Figure 61).6. Remove the drain plug from the gear box andallow the oil to drain into a pan. Remove thefill plug to ease in draining of the oil.Figure 611. Drain plug7. Add enough oil to bring the level up tothe bottom of the check plug holes; referto Checking the Rear Axle Lubricant, andChecking the Rear Axle Gear Box Lubricant.8. Install the plugs.Checking the Rear WheelToe-InAfter every 800 operating hours or annually, checkthe rear wheel toe-in.44