Toro 30410 Operator's Manual

Also see for Groundsmaster 4000-D: Installation instructions Service manual Service manual Service manual Service manual

Contents

Figure 101. Check/drain plug2. Remove the plug on the planetary (Figure 10)and check the plug on the back side of thebrake (Figure 11). Oil should be at the bottomof the check plug hole on the back side of thebrake.Figure 111. Brake housing 2. Check plug3. Add gear oil to the hole in the planetary, ifnecessary, to bring the oil up to the properlevel. Install the plug.4. Repeat steps 1-3 on the opposite gear assembly.Checking the Rear Axle LubricantThe rear axle is shipped from the factory filledwith SAE 85W-140 gear lube. Check the oil levelbefore the engine is first started and every 400hours thereafter. The capacity is 80 oz (2.4 l).Visually inspect for leaks daily.1. Position the machine on a level surface.2. Remove a check plug from one end of the axle(Figure 12) and make sure that the lubricantis up to the bottom of the hole. If the level islow, remove the fill plug (Figure 12) and addenough lubricant to bring the level up to thebottom of the check plug holes.Figure 121. Check plug 2. Fill plugChecking the Rear Axle Gear BoxLubricantThe gear box is shipped from the factory filledwith SAE 85W-140 gear lube. Check the oil levelbefore the engine is first started and every 400hours thereafter. The capacity is 16 oz (0.5 l).Visually inspect for leaks daily.1. Position the machine on a level surface.2. Remove the check/fill plug from the left sideof the gear box (Figure 13) and make sure thatlubricant is up to the bottom of the hole. If thelevel is low, add enough lubricant to bring thelevel up to the bottom of the hole.22