Toro 22322 Operator's Manual

Also see for 22321: Operator's manual Operator's manual Quick start quide Operation and Safety Guide Setup instructions

MaintenanceNote: Determine the left and right sides of the machine from the normal operating position.Recommended Maintenance Schedule(s)Maintenance ServiceInterval Maintenance ProcedureAfter the first 8 hours • Replace the hydraulic filter.After the first 50 hours • Change the engine oil and filter.• Check and adjust the track tension.Before each use or daily• Check the engine-oil level.• Grease the traction unit. (Grease immediately after every washing.)• Check the air-filter-service indicator.• Clean the tracks.• Check the tracks for excessive wear (If the tracks are worn, replace them.)• Remove debris from the traction unit and side screens.• Check for loose fasteners.Every 25 hours• Check the hydraulic-fluid level.• Remove air-cleaner cover, clean out debris, and check the air-filter-service indicator.• Inspect the drive belt for wear or damage.Every 100 hours• Change the engine oil.• Check the battery electrolyte level (replacement battery only).• Check the battery cable connections.• Check and adjust the track tension.• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mountingsupports, wear, weather, and chemical deterioration.• Check for dirt build-up in the chassis.Every 200 hours• Replace the carbon-canister air filter (Service more frequently if conditions areextremely dusty or sandy).• Replace the carbon-canister purge-line filter (Service more frequently when usingthe vibratory plow attachment).• Change the oil filter.• Check the spark plugs.• Change the fuel filter.• Replace the drive belt.• Replace the hydraulic filter.Every 250 hours • Check and grease the road wheels.Every 400 hours • Change the hydraulic fluid.Every 1,500 hours • Replace all moving hydraulic hoses.Yearly or before storage • Check and adjust the track tension.• Touch up chipped paint.Important: Refer to your engine owner’s manual for additional maintenance procedures.Note: After 50 hours and then every 100 hours thereafter (150, 250, 350, etc.), the hour meter displays CHG OIL to remindyou to change the engine oil. After every 100 hours, the screen displays SVC to remind you to perform the other maintenanceprocedures based on a 100-, 200-, or 400-hour schedule. These reminders come on starting 3 hours prior to the service intervaltime and flash at regular intervals for 6 hours.24