Toro TX 427 Quick Start Quide

Also see for 22321: Operator's manual Operator's manual Operation and Safety Guide Setup instructions Operator's manual

Form No. 3403-186 Rev ATX 427 Compact Tool CarrierModel No. 22321—Serial No. 316000001 and UpModel No. 22321G—Serial No. 316000001 and UpModel No. 22322—Serial No. 316000001 and UpCharging the BatteryWARNINGCALIFORNIAProposition 65 WarningBattery posts, terminals, and relatedaccessories contain lead and lead compounds,chemicals known to the State of Californiato cause cancer and reproductive harm.Wash hands after handling.1. Open the rear access cover.2. Connect a charger to the battery (Figure 1) and chargeit for a minimum of 1 hour at 6 to 10 amps. Do notovercharge the battery.12 34G003792Figure 11. Positive post 3. Charger red (+) wire2. Negative post 4. Charger black (—) wireWARNINGCharging the battery produces gasses that canexplode.Never smoke near the battery and keep sparksand flames away from battery.3. When the battery is fully charged, unplug the chargerfrom the electrical outlet, then disconnect the chargerleads from the battery posts (Figure 1).4. Close the rear access cover.Checking Fluid LevelsBefore starting the engine for the first time, check the engineoil and hydraulic fluid levels. Refer to the Operator's Manualfor more information.Setting the Engine RPM (CEOnly)If you are setting up this machine for use in the EuropeanCommunity (CE), you need to permanently adjust the enginespeed so that it does not run above 3300 RPM, as follows:1. Start the engine and run it at half throttle for 5 to 10minutes to warm it up.Important: The engine must be warm beforemaking this adjustment.2. Move the throttle lever to the Fast position.3. Check the engine speed on the tachometer.It should be around 3600 RPM.4. Loosen the jam nut securing the high idle adjustingscrew on the engine (located on the throttle/chokecontrol linkage—Figure 2).G009157123Figure 21. High idle adjusting screw 3. Throttle/choke controllinkage2. Jam nut© 2016—The Toro® Company8111 Lyndale Avenue SouthBloomington, MN 55420Register at www.Toro.com. Original Instructions (EN)Printed in the USAAll Rights Reserved *3403-186* A

/ 2

Related manuals for Toro 22321