Toro 22321 Operator's Manual

Also see for 22321: Operator's manual Quick start quide Operation and Safety Guide Setup instructions Operator's manual

Figure 241. Hand knob2. Tilt the rear access cover down and remove to accessthe internal components (Figure 24).Closing the Rear AccessCover1. Move the rear access cover in place over the backof the traction unit making sure the tabs line up inthe slots.2. Push the access cover forward, lining up the handknob screws with the threaded holes in the machine.3. Screw the hand knobs tight to secure the rear accesscover in place.Removing the Side Screens1. Open the hood.2. Slide the side screens (Figure 25) up and out of theslots in the front screen and frame.Figure 251. Side screenInstalling the Side ScreensSlide the side screens into place in the slots in the frontscreen and frame.Removing the Front ScreenIf the engine has been running the heat shieldwill be very hot and could burn you.Allow the traction unit cool completely beforetouching the heat shield.1. Open the hood and remove both side screens.2. Loosen the bolts securing the front weight(Figure 26).Figure 261. Front weight 3. Heat shield2. Bolts 4. Carriage bolts3. Remove the carriage bolts and nuts securing the heatshield (Figure 26).4. Lift the heat shield up and off of the traction unit.5. Remove the 4 bolts securing the front screen to thetraction unit frame (Figure 27).Figure 271. Front screen 2. Bolts (left side bolt notshown)24