Tascam HS-P82 Owner's Manual

Also see for HS-P82: Software manual User guide Manual Release note Notice

Contents

Tascam HS-P82 Owner's Manual Manual pdf 52 page image

52 TASCAM HS-P824 Touch the OK button to start the connection with thecomputer. The following screen appears while theunit is connected to a computer.CAUTIONThis unit receives power from batteries or an AC adaptor. It•cannot be powered by USB.Do not connect the unit to a computer by USB when the•battery level is low. If the power is disrupted during datatransfer, data could be lost and that data might not berecoverable.Disconnecting from a computerUse the following procedures to disconnect from acomputer. Always follow these procedures carefully becausefailure to do so could result in damage to some files.CAUTIONDo not interrupt the USB connection or disconnect the USBcable during data transfer. Doing so could damage data on thecomputer or this unit.1 Close connections from the computer. The HS-P82has two CF card slots. Use the following proceduresto close the connections for each card.Disconnecting from Windows XP, Windows Vistaor Windows 7Right-click the CF card device (the E drive in theillustration) that you want to eject using Windows Explorerand select eject.NOTEIf you click the Safely Remove Hardware icon in the systemtray (usually at the bottom right of the screen) and eject thehardware, both CF cards in the HS-P82 slots are ejected. Toreconnect with the computer, disconnect and reconnect theUSB cable once.Disconnecting from a MacintoshDrag the HS-P82 icon for this device to the trash, selectit and type Command + E or select “Eject” from the Filemenu to eject a card.NOTEDepending on the OS version and settings, you can also ejectthe card by clicking the eject icon next to the HS-P82 driveshown in the Finder window or by control-clicking the iconand selecting “Eject” from the contextual menu.At this point, it is safe to remove CF cards from the unit.You can also insert a different CF card and continuerecording.2 Close the connection from this unit.To close the connection with the computer from thisunit, touch the CANCEL button. The following messageappears in a pop-up window.8 – Transferring Data between the Unit and a Computer