Sony STR-DN840 Operating Instructions Manual

Also see for STR-DN840: Limited warranty Quick setup guide Specifications Operating instructions Operating instructions

Contents

39USPreparing the Receiver(Depending on the networkenvironment, the network settings maytake some time.)3 Perform the server settings.To listen to audio content stored on theserver, you need to set up your server(page 57).When checking the network settings, see“Information” (page 95).Setting up a wirelessnetwork using the WPS PINcode methodIf the access point supports the WPS PIN(Personal Identification Number) codeconnection, you can set up a WPS wirelessconnection by entering the receiver’s PINcode into the wireless LAN router/accesspoint.1 Select “Manual Registration” in step2 in “Searching for an access pointand setting up a wireless network(Access Point Scan method)”(page 37).2 Press V/v repeatedly to select “WPSPIN”, then press .The available SSID (access point) listappears.3 Press V/v repeatedly to select thenetwork name (SSID) you want, thenpress .The PIN code (8 digits) of the receiverappears on the TV screen. Leave the PINcode displayed until the connection iscomplete. (A different PIN code isdisplayed each time you perform thisoperation.)4 Input the receiver’s PIN code into thewireless LAN router/access point.The receiver starts the network settings.“Completed” appears after the networksettings are complete and “ ” lightsup on the display panel. To return to theNetwork Settings menu, press .(Depending on the networkenvironment, the network settings maytake some time.)5 Perform the server settings.To listen to audio content stored on theserver, you need to set up your server(page 57).• When checking the network settings, see“Information” (page 95).• For details on entering the PIN code into thewireless LAN router/access point, refer to theoperating instructions of the wireless LANrouter/access point.If you cannot find thenetwork name (SSID) youwant (manual setupmethod)You can input the network name (SSID)you want manually if it does not appear onthe list.1 Select “Manual Registration” in step2 in “Searching for an access pointand setting up a wireless network(Access Point Scan method)”(page 37).2 Press V/v repeatedly to select“Direct Input”, then press .3 Enter the network name (SSID), thenpress .4 Press V/v repeatedly to select thesecurity setting you want, then press.5 Follow steps 4 to 7 in “Searching foran access point and setting up awireless network (Access Point Scanmethod)” (page 37).Tip Tips