94 Chapter 4 Viewfinder Screen Indications and MenusChapter 4 Viewfinder Screen Indications and MenusViewfinder Basic MenuBasic menu page 5This menu is displayed when CAM is selected on thebasic menu page 4 and an external sync signal is inputto the GEN LOCK IN connector.a) This applies when using an external sync signal tosynchronize operation of several camcorders (see page 50).NoteThis page is not displayed when a CCU (cameracontrol unit) is connected.Basic menu page 6Item SettingsSC PHASESub carrier phase adjustment forwhen the camcorder is genlocked.a)000 to 999H PHASEHorizontal phase adjustment forwhen the camcorder is genlocked.a)000 to 135 (normal value)to 199Item SettingsMARKERSets marker display ON/OFF.ON (normal value), OFFMarkers are displayedwhen this setting is ONand is not displayedwhen it is OFF.When the setting is ON,go to advanced menupage 4 to select the typeof marker(see page102).DUR TIMESets the recording time.Setting the recording time beforeshooting helps you with makingscenes of equal duration.When shooting with displayingthe recording time of the currentcut in the viewfinder (with theREC TIME switch set to DUR),the recording time indicationflashes to remind you that therecording time has passed.00:00 to 59:59 (minute :second)See “Setting therecording time inseconds”.Setting the recording time in secondsMove the cursor to DUR TIME, then press the MENUdial.A value of seconds appears.If you turn the MENU dial when “59” is displayed, thenumber under “MM” increased by one.
