Chapter 5 Adjustments and Settings 123Chapter 5 Adjustments and SettingsMenu 212 Selecting AudioRecording ModeThe audio recording mode can be set to either of thefollowing modes.48-kHz mode (factory setting): Enables two-channel recording mode with 48-kHz samplingfrequency.32-kHz mode: Enables four-channel recording modewith 32-kHz sampling frequency (for CH-1 andCH-2).1 Display menu 212.The menu number and current audio recordingmode is displayed.Example: 48 (2-channel mode with 48-kHzsampling frequency)If the setting does not need to be changed, pressthe MENU button to close the menu.2 Press the SHIFT button to make the audiorecording mode indication start blinking, thenpress the ADVANCE button.This switches the mode setting to the other audiorecording mode.Example: 32 (4-channel mode with 32-kHzsampling frequency)3 Press the RESET/(MENU SET) button and thenthe MENU button.The settings are recorded and display windowreturns to the display shown before the VCR menu.Menu 211 Selecting ClipLinkFunctionThis setting must be made when not using theClipLink function.For details of the ClipLink function, see “ClipLinkShooting” (page 77).1 Display menu 211.The ClipLink function is factory-set to on.If the setting does not need to be changed, pressthe MENU button to close the menu.2 Press the SHIFT button to make the ClipLinkfunction on/oFF indication start blinking. Press theADVANCE button to change the indication tooFF.3 Press the RESET/(MENU SET) button and thenthe MENU button.The settings are recorded and display windowreturns to the display Ûêown before the VCR menu.BlinkingAudio recording modeindicationBlinkingClipLink function on/oFFindicationBlinking
