Sony BRAVIA KD-65AF8 Reference Manual

Also see for BRAVIA KD-55AF8: Service manual

4GBTransporting• Before transporting the TV set, disconnect all cables.• Two or three people are needed to transport a large TV set.• When transporting the TV set by hand, hold it as shown below.Do not put stress on the panel and the frame around the screen.• When handling or mounting theTV set, do not lay down the TV.• When transporting the TV set, donot subject it to jolts or excessive vibration.• When transporting the TV set for repairs or when moving, packit using the original carton and packing material.Topple preventionVentilation• Never cover the ventilation holes or insert anything in thecabinet.• Leave space around the TV set as shown below.• It is strongly recommended that you use a Sony Wall-MountBracket in order to provide adequate air circulation.Installed on the wallInstalled with stand• To ensure proper ventilation and prevent the collection of dirt ordust: Do not lay the TV set flat, install upside down, backwards, orsideways. Do not place the TV set on a shelf, rug, bed or in a closet. Do not cover the TV set with a cloth, such as curtains, or itemssuch as newspapers, etc. Do not install the TV set as shown below.Mains leadHandle the mains lead and socket as follows in order to avoid anyrisk of fire, electric shock or damage and/or injuries:• Use only mains leads supplied by Sony, not other suppliers.• Insert the plug fully into the mains socket.• Operate the TV set on a 220 V - 240 V AC supply only.• When wiring cables, be sure to unplug the mains lead for yoursafety and take care not to catch your feet on the cables.• Disconnect the mains lead from the mains socket beforeworking on or moving the TV set.• Keep the mains lead away from heat sources.• Unplug the mains plug and clean it regularly. If the plug iscovered with dust and it picks up moisture, its insulation maydeteriorate, which could result in a fire.Note• Do not use the supplied mains lead on any other equipment.• Do not pinch, bend, or twist the mains lead excessively. The coreconductors may be exposed or broken.• Do not modify the mains lead.• Do not put anything heavy on the mains lead.• Do not pull on the mains lead itself when disconnecting themains lead.• Do not connect too many appliances to the same mains socket.• Do not use a poor fitting mains socket.M4 screw (not supplied)Cord(not supplied)Screw (not supplied)6 mm - 7 mm30 cm10 cm 10 cm10 cmLeave at least this space around the set.30 cm10 cm 10 cmLeave at least this space around the set.6 cmDo not block the air circulation area.Air circulationWallAir circulation is blocked.Wall