3 Milling Cycles 12.973.17 High Speed Settings – CYCLE832 (SW 6.3 and higher) 3© Siemens AG, 2002. All rights reserved3-268 SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition3.17.4 InterfacesG codesList of the G commands programmed in CYCLE832:• G64, G641, G642• G601• FFWON, FFWOF• SOFT, BRISK• COMPCAD, COMPCURV,COMPOF,B-SPLINE• TRAORI, TRAORI(2),TRAOFOF• UPATHNote: The G commands should not be generated in the subsequentCAM program. Technology – Geometry separation.Machine dataThe following machine data is evaluated in cycle CYCLE832:MD No. MD identifiers Comments10071 $MN_IPO_CYCLE_TIME – interpolation cycle20480 $MC_SMOOTHING_MODE20482 $MC_COMPRESSOR_MODE20490 MC_IGNORE_OVL_FACTOR_FOR_ADISThe following machine data is rewritten in cycle CYCLE832:MD No. MD identifiers Comments33100 COMPRESS_POS_TOL[AX] Geometry axes 1...333100 COMPRESS_POS_TOL[AX] Rotary axes 1 and 2 1)32310 MAX_ACCEL_OVL_FACTOR[AX] Geometry axes 1...332310 MAX_ACCEL_OVL_FACTOR[AX] Rotary axes 1 and 2 1)1) as per 5-axis transformation machine dataSetting dataList of setting data rewritten in CYCLE832:SD no. SD identifier Comments42465 $SC_SMOOTH_CONTUR_TOL Corresp. to the tolerance of the linear axes42466 $SC_SMOOTH_ORI_TOL Corresp. to the tolerance of the rotary axes42475 $SC_COMPRESS_CONTUR_TOL for COMPCURV only42476 $SC_COMPRESS_ORI_TOL for COMPCURV only42477 $SC_COMPRESS_ORI_ROT_TOL for COMPCURV only1) The efficiency of setting data $SC_SMOOTH_CONTUR_TOL and$SC_SMOOTH_ORI_TOL depends on MD20480: $MC_SMOOTHING_MODE.The efficiency of setting data $SC_COMPRESS_CONTUR_TOL and$SC_COMPRESS_ORI_TOL depends on MD20482: $MC_COMPRESSOR_MODE11.02
