Siemens SINAMICS G130 Operating Instructions Manual

Also see for SINAMICS G130: Manual Operating instructions Operating instructions List manual Operating instructions

Contents

Commissioning5.5 First commissioning with the AOP30Inverter chassis unitsOperating Instructions, 07/2016, A5E00331449A 175NoteSelecting the motor typeThe selection of the motor type pre-assigns specific motor parameters and optimizes theoperating characteristics and behavior. Details are described in the List Manual in the p0300parameter.NoteSelection of a list motor (p0300 ≥ 100)When a motor type ≥ 100 is selected, the article number of the associated motor can beselected via drop-down list.NoteCommissioning an induction motorThe steps described below also apply to commissioning an induction motor.When commissioning a permanent-magnet synchronous motor (p0300 = 2), there are a fewspecial conditions that apply, which are detailed in a separate chapter (see "Setpointchannel and closed-loop control/Permanent-magnet synchronous motors").Basic commissioning: entering the encoder data (if available)When the SMC30 is connected for encoderevaluation, it is recognized by the AOP30and a screen is displayed in which you canenter the encoder data.To navigate through the selection fields,choose or .To activate a selection, choose .