Siemens G130 List Manual

Also see for SINAMICS G130: Manual Operating instructions Operating instructions Operating instructions Operating instructions

Contents

4 Faults and alarms4.2 List of faults and alarmsSINAMICS G130/G1501926 List Manual (LH2), 07/2016, A5E03263479AF40825 CX32 DRIVE-CLiQ: Supply voltage failedMessage value: Component number: %1, fault cause: %2Message class: Supply voltage fault (undervoltage) (3)Drive object: All objectsComponent: DRIVE-CLiQ Hub Module (Hub) Propagation: LOCALReaction: OFF1 (OFF2)Acknowledge: IMMEDIATELYCause: The DRIVE-CLiQ communication from the DRIVE-CLiQ component involved to the Control Unit signals that thesupply voltage has failed.Fault cause:9 (= 09 hex):The power supply voltage for the components has failed.Note regarding the message value:The individual information is coded as follows in the message value (r0949/r2124):0000yyxx hex: yy = component number, xx = error causeRemedy: - carry out a POWER ON (switch-off/switch-on).- check the supply voltage wiring of the DRIVE-CLiQ component (interrupted cable, contacts, ...).- check the dimensioning of the DRIVE-CLiQ component power supply.F40835 CX32 DRIVE-CLiQ: Cyclic data transfer errorMessage value: Component number: %1, fault cause: %2Message class: Internal (DRIVE-CLiQ) communication error (12)Drive object: All objectsComponent: DRIVE-CLiQ Hub Module (Hub) Propagation: LOCALReaction: OFF2Acknowledge: IMMEDIATELYCause: A DRIVE-CLiQ communications error has occurred from the Control Unit to the controller extension involved. Thenodes do not send and receive in synchronism.Fault cause:33 (= 21 hex):The cyclic telegram has not been received.34 (= 22 hex):Timeout in the telegram receive list.64 (= 40 hex):Timeout in the telegram send list.Note regarding the message value:The individual information is coded as follows in the message value (r0949/r2124):0000yyxx hex: yy = component number, xx = error causeRemedy: - carry out a POWER ON (switch-off/switch-on).- replace the component involved.See also: p9916 (DRIVE-CLiQ data transfer error shutdown threshold slave)F40836 CX32 DRIVE-CLiQ: Send error for DRIVE-CLiQ dataMessage value: Component number: %1, fault cause: %2Message class: Internal (DRIVE-CLiQ) communication error (12)Drive object: All objectsComponent: DRIVE-CLiQ Hub Module (Hub) Propagation: LOCALReaction: OFF2Acknowledge: IMMEDIATELYCause: A DRIVE-CLiQ communications error has occurred from the Control Unit to the controller extension involved. Datawere not able to be sent.Fault cause:65 (= 41 hex):Telegram type does not match send list.