Sharp XE-A507 Instruction Manual

Also see for XE-A507: User manual Setup guide Quick start guide Manual de instrucciones

Contents

94SD CARD ModeYou can exchange data through an SD memory card between your register and a PC when managing thedata in your register by using the SHARP’s PC software “Customer Support Tool”.Customer Support Tool can be downloaded from the Sharp web site.Please visit the Sharp web site: http://www.sharpusa.com/registersoftwareYou can also save all necessary data in the register to an SD memory card for backup.To use the SD memory card function, select the “7 SD CARD MODE” in the mode selection window andperform the following operations.This instruction manual describes only those operations needed on the register. For details, please refer tothe help section in the “Customer Support Tool”.■ Inserting and removing an SD memory cardThe SD card slot is located on the front side of your register.Inserting an SD memory cardInsert an SD memory card into the SD card slot with the printedSD logo facing upwards. Push the card in steady with a fingeruntil it clicks and release it slowly.Removing the SD memory cardPush the card in gently with a finger and release it. The card willcome out.NOTE• This model supports SD cards only. Use of any other types ofSD cards such as mini SD, micro SD, etc. with an adapter is not supported.• When inserting or removing the SD memory card, be sure to release it slowly. Otherwise, the card may popout and injure your finger.• Never touch or remove the SD memory card while it is accessed, otherwise the data stored in it may bedamaged.• Formatting the SD memory card erases all the data in it.CAUTION: Never turn the power off, while the SD memory card is accessed.■ SD card formattingWhen the SD card is not formatted yet, take the formatting operation.Procedure(1) Select “4 FORMATTING” in the SD CARD mode and press the A key, the confirmation windowis displayed.(2) To perform the format operation, select OK and press the A key.To cancel the operation, select CANCEL and press the A key.■ Folder creatingA user folder can be created in the following location:SHARP/ECRER3X7/nnnnnnnn (nnnnnnnn: user folder name)Procedure(1) Select “3 FOLDER CONTROL” in the SD CARD mode and press the A key.(2) Select “1 CREATE FOLDER” and press the A key, the folder name entry window is displayed.(3) Enter the required folder name and press the A key.To cancel the operation, press the a key.