Sharp Sunrise SPC268 Instruction Manual & Warranty

SPC268 Sunrise Alarm Clock with USB PortInstruction Manual & WarrantyThank you for your purchase of this quality clock. The utmost care has gone into the design andmanufacture of your clock. Please read these instructions and store them in a safe place for futurereference.1. PM indicator2. Alarm 1 indicator3. USB charging port4. Alarm 2 indicator5. Sunrise indicator6. SUNRISE button7. ALARM 1 button8. ALARM 2 buttonCONNECTING TO THE POWER SUPPLYBegin by plugging in the AC adapter into a standard household outlet and the other end of the cord intothe DC 5V jack at the back of the unit.INSTALLING THE CLOCK & ALARM BACKUP BATTERIESThe clock time and alarm (if set) can be maintained during a power failure by 2 x AAA/ LR03 batteries (notsupplied). Once the power is restored, check the time to make sure it is accurate and re-set if necessary.Note: When battery backup is in use the display will NOT be lit. However, the clock will continue tofunction and the alarm will go off at its set time.INSERTING THE BATTERIES1. Open the battery compartment at the back of the unit by pressing on the catch and removing the cover.2. Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery compartment, followingthe polarity as shown on the diagram inside the compartment.3. Replace the battery compartment cover.USB CHARGINGTo charge, connect your USB device to the USB port of this clock.Note:- Use only with devices that require 5V USB power.- The USB port provides 2,000mA recharging current. Devices requiring more than 2,000mA should notbe used.- Charging time may vary for different devices.SETTING THE CLOCK- Press and hold the TIME button down to activate time setting.- While holding down the TIME button, press the HOUR button to advance to the correct hour. The PMindicator will light when the hour is advanced into the PM time.- While holding down the TIME button, press the MIN button to advance to the correct minute.- Release the TIME button when the correct time is shown on the display.- Press and hold the ALARM 1 / 2 button down to activate alarm setting.- While holding down the ALARM 1 / 2 button, press the HOUR button to advance to the correct hour.The PM indicator will light when the hour is advanced into the PM time.- While holding down the ALARM 1 / 2 button, press the MIN button to advance to the correct minute.- Release the ALARM 1 / 2 button when the correct alarm time is shown on the display.USING THE ALARM FUNCTION- Press the ALARM 1 / 2 button to activate the alarm and the alarm indicator will be lit.- Press the ALARM 1 / 2 button again to deactivate the alarm and the alarm indicator no longer be visible.SNOOZE FUNCTION- Pressing the SNOOZE button after the alarm sounds will cause the alarm to stop and the alarm willsound again in 9 minutes. This will happen each time the SNOOZE button is pressed.COLOR CHANGING LIGHT FUNCTION- Press the COLOR button to activate the color changing light.- Press the COLOR button again if you want to freeze the color.- Press and hold the COLOR button to deactivate the color changing light.SUNRISE LIGHT FUNCTIONThis alarm clock has sunrise light function where the light will gradually light up 30 minutes beforethe alarm sounds.- Press the SUNRISE button to activate this function once the ALARM 1 is set.- To cancel it, press the SUNRISE button.Note: ALARM 1 is enabled with the SUNRISE function; alarm 2 is NOT.CARE OF YOUR CLOCK- Replace the back up battery annually, or store the clock without a battery when not in use.- A soft cloth or a paper towel may be used to clean your clock.- Do not use any corrosive cleanser or chemical solutions on the clock.- Keep your clock dry; if it gets wet, wipe it dry immediately. Keep your clock away from dust and dirt.Handle your clock carefully; do not drop it.- Do not subject the clock to excessive force, shock, dust, temperature, or humidity. Any of theseconditions may shorten the life of the clock.- Do not tamper with any of the internal components of this clock. This will invalidate the warranty andmay cause damage.SETTING THE ALARM6 7 89. DC 5V jack10. HOUR button11. MIN button12. COLOR button13. TIME button14. Battery compartment15. SNOOZE buttonSPC268DC 5V1 2 4 53 9 10 1211 1314 15

/ 2

Related manuals for Sharp Sunrise SPC268