Sharp SPC658 Instruction Manual & Warranty

SPC658 LED Alarm Clock with BluetoothInstruction Manual & WarrantyThank you for your purchase of this quality clock. The utmost care has gone into the design and manufacture of yourclock. Please read these instructions and store them in a safe place for future reference.FEATURES1. PM indicator2. POWER ON/OFF button3. VOL - button4. PLAY/PAUSE/SNOOZE button5. VOL + button6. Bluetooth indicator7. Alarm indicator8. HOUR button9. MIN button10. AUX IN jack11. DC 5V jack12. Battery compartment13. ALARM ON/OFF switch14. ALARM button15. Speaker16. TIME buttonCONNECTING TO THE POWER SUPPLYInsert the AC adaptor into a 120V AC ~ 60Hz mains outlet and the other end of the cord into the DC 5V jack on theback of the unit.INSTALLING THE CLOCK & ALARM BACK UP BATTERIESThe clock time and alarm time (if set) can be maintained during a power failure by 2 x AAA/ LR03 batteries (notsupplied). However, once the power is restarted, check the time to make sure it is accurate and reset if necessary.INSERTING THE BATTERIES1. Open the battery compartment at the back of the unit by pressing on the catch and removing the cover.2. Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery compartment, following the polarityas shown on the diagram inside the compartment.3. Replace the battery compartment cover.SETTING THE CLOCK- Press and hold the TIME button down to activate time setting.- While holding down the TIME button, press the HOUR button to advance to the correct hour. The PM indicator willlight when the hour is advanced into the PM time.- While holding down the TIME button, press the MIN button to advance to the correct minute.- Release the TIME button when the correct time is shown on the display.SETTING THE ALARM- Press and hold the ALARM button down to activate alarm setting.- While holding down the ALARM button, press the HOUR button to advance to the correct hour. The PM indicatorwill light when the hour is advanced into the PM time.- While holding down the ALARM button, press the MIN button to advance to the correct minute.- Release the ALARM button when the correct alarm time is shown on the display.USING THE ALARM FUNCTION- Slide the ALARM ON/OFF button to ON to activate the alarm and the alarm indicator will be lit.- Slide the ALARM ON/OFF button to OFF to deactivate the alarm and the alarm indicator no longer be visible.SNOOZE FUNCTION- Pressing the SNOOZE button after the alarm sounds will cause the alarm to stop and the alarm will sound again in9 minutes. This will happen each time the SNOOZE button is pressed.USING BLUETOOTH FUNCTION- Press the POWER ON button to enter Bluetooth mode. The Pairing Indicator will flash blue quickly.- Using the native controls on your Bluetooth device, select the “SPC658” in your Bluetooth settings to pair.When pairing, remain within 3 feet of the unit.1 2 3 4 5 6 7 8 9 10 11 12 1314 15 16

/ 2

Related manuals for Sharp SPC658