Sharp MX-4110N Installation Manual

Also see for MX-4110N: Operation manual Operation guide

Contents

MX-5111N Dehumidifying heater 3 – 32) Remove the snap band. Insert the supporter (package part No.3) to the frame of the power unit, and attach the WH PWB(package part No. 4) on it.NOTE: Be careful not to break the PWB when mounting the PWBto the supporters.3) Connect the harness to the WH PWB.4) Connect the AC-WH harness 1 (package part No. 5) to the ACPWB, the WH PWB and the dehumidifier heater switch.NOTE: The AC-WH harness 1 should pass under the MSW har-ness.C. Installation of the heater kit(1) Assembling of the heater unit1) Attach the heater (package part No. 6) to the heater mountingplate (package part No. 7), and secure it with the screw (M3x6S-tight) (package part No. 8).2) Attach the heater mounting plate to the T-Heater cover (pack-age part No. 9), and secure it with the screw (M3x6 S-tight)(package part No. 8).Attach the snap band of the heater harness to the T-Heatercover.NOTE: After installing, check that the harness of the heater gostraight into the T-Heater cover.3) Attach the caution label (package part No. 10) to the T-Heatercover.NOTE: Wipe the surface where the label is to be affixed with alco-hol, then attach the label along the reference line.Reference lineReferenceline