Sharp LC-70UQ17U Operation Manual

Also see for LC-90LE657U: Technical specifications Setup guide Operation manual Setup guide Operation manual

Contents

On-Screen Display MenuENG 4-23Example Smart TV (Continue)WallpaperActivating the function will display still images when the TVis in standby mode.Wallpaper ModeConfigures Wallpaper Mode settings.Off:Nothing will be displayed.Picture:Still images will be displayed when the TV is instandby mode.Clock: The clock will be displayed when the TV is instandby mode.Configure the clock settings. (For the UQ17U, TQ15U,SQ17U, SQ15U, SQ10U and EQ10U models)(See page 4-24.)NOTEThe clock mode can only be used when a networkconnection has been established.Finish configuring the network settings.After you set the time once, the clock will continue tooperate even if you disconnect from the network.However, you cannot switch the daylight saving timesetting when disconnected from the network.Data SourceFor the wallpaper, you can select either the still images pre-installed in the TV or your favorite still images stored in theUSB memory device.Pre-Installed: The images pre-installed in the TV will bedisplayed in a slideshow.USB: Your favorite images stored for the wallpaper willappear.If only a single still image is stored in the USB memorydevice, that image will be displayed as the wallpaper.When there are multiple still images in the memory, allthe images will be displayed in a slideshow.NOTEImages are displayed in 3-minute intervals as aslideshow.When the TV is in Wallpaper mode, you can turn off theTV by pressing and holding POWER on the TV for 5seconds.- Just before the TV turns off, the last image shownwhen the TV was turned off appears briefly.- Your settings may not be saved in some cases.When you display images by using the USB memorydevice:Create a folder named "WP" in the root directory of theUSB memory device (the first directory when the USBmemory device is opened), and store into the folder thestill images you want to display for the wallpaper.You must insert the USB memory device into the USBterminal before turning off the TV.If there are images on the USB memory device but theydo not appear on the screen, switch to USB mode andcheck whether the image files on the USB memorydevice are shown correctly.Timer SettingYou can set the length of time the TV will remain in theWallpaper Mode.3 hours/6 hours/12 hours/24 hoursNOTENo buttons except for POWER work even while the stillimages are being displayed.If the ready-for-use USB memory device is not inserted,the still images pre-installed in the TV will be displayed ina slideshow even when "Data Source" is set to "USB".Because the USB memory device cannot be detectedimmediately after the TV is turned on from standbymode, the wallpaper pre-installed in the TV may bedisplayed even when "Data Source" is set to "USB".The still images will be displayed until the set time haselapsed.