Sharp LC-70UQ17U Operation Manual

Also see for LC-90LE657U: Technical specifications Setup guide Operation manual Setup guide Operation manual

Contents

Using a PCENG 8-3Control of the TVThe TV can be controlled from a PC, control panels and other devices using the RS-232C or IP.Use a cross-type RS-232C cable, ETHERNET cable (commercially available) or wireless LAN forthe connections.NOTEThis operation system should be used by a person who is accustomed to using computers.AQUOS Remote ControlSet this function when operating the TV from equipment connected by LAN or wireless LAN. Toperform the operation, refer to "Smart TV".Remote Control AppWhen "Remote Control App" is selected, "Change" will be highlighted. Press ENTER.Detailed SettingsMake the detailed settings (Login ID, password, etc.).Follow the on-screen instructions to configure the settings.TV Name SettingSet the name of the TV displayed on other network devices.Use the software keyboard to set the name.See page 9-5 for details on the software keyboard.Communication Conditions for IPConnect to the TV with the following settings made for IP on the PC.IP protocol: TCP/IPHost IP address: Set the IP address on the TV menuService: None (Do not select Telnet or SSH)TCP port#: Set a port number on the TV menu (Controlport)When you set your ID and password on the TV menu, you need to enter them as soon as youconnect to the TV.NOTEWhen you use this function, make settings for "AQUOS Remote Control".The connection will be cut off when there has been no communication for 3 minutes.Communication Conditions for RS-232CSet the RS-232C communication settings on the PC to match the TV's communication conditions.The TV's communication settings are as follows:Baud rate: 9,600 bpsData length: 8 bitsParity bit: NoneStop bit: 1 bitFlow control: NoneCommunication procedureSend the control commands from the PC via the RS-232C or IP.The TV operates according to the received command and sends a response message to the PC.Do not send multiple commands at the same time.Wait until the PC receives the OK response before sending the next command.