Sealey TC10A Instructions Manual

instructions fortyre changer - assist arm for tc10model no: tc10athank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.refer toinstructionscrushing ofhands hazardWear eyeprotectionWear protectiveglovesWear earprotectionWear safetyfootwearWear protectiveclothing1. safety Warning! ensure that Health & safety, local Authority regulations and general workshop practice regulations are adhered towhen using tyre changer. read and fully understand instructions and safety labels attached to machine.9 Wear appropriate Personal Protective equipment. A full range of Personal Protective equipment is available from your sealey stockist.9 Wear suitable clothing to avoid snagging. Do not wear jewellery. tie back long hair.9 maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.8 Do not use tyre changer assist arm if damaged.9 this machine should only be operated by trained personnel.9 This machine should only be used for the purpose for which it is intended and not modified in any way.9 Warning! the warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. the operator/user must apply caution and common sense.2. introDuctionthe assist arm is a must have for mounting and dismounting low profile and run flat tyres and is for use in conjunction with Model No. TC10 Tyrechanger. operated by air supply from tyre changer. single air ram operates three separate arms with one control lever. see sealey website fordemonstration video.3. specificationmodel no..................................................................... TC10AHeight ...................................................................... 1220mmHeight when mounted .............................................. 1550mmoperating pressure ............................... 8-10bar (115-145psi)Weight ............................................................................ 72kg4. positioning anD assembly4.1. Remove packaging and check contents according to the accessory list and fig.1. Clean for assembly. The assembled appearance isas shown in the fig.2.fig.1 fig.2tC10A | Issue 1 06/02/18Original Language Version© Jack sealey limitedAccessorY list:-1. Ø8PU hose2. Ø8 Y-Tee3. Plate4. Cushion5. Screw M10X130 (nut,flat washer) 4sets6. Screw M10X25 (nut,flat washer) 2sets7. Screw M10X20(flat washer) 2sets8. fix plate9. tool box.fig.2 Key1. Roller Arm - to push down on the top bead of the tyre. Used when removingand fitting the tyre.2. Disc Arm - to push up the bottom tyre bead. Used when removing the tyre.3. Bead Holding Arm - to hold the top bead in position when fitting so tyre beaddoes not slip off. Used when fitting the tyre.

/ 4

Related manuals for Sealey TC10A