Sealey STW291 Instructions For

INSTRUCTIONS FOR:DIGITAL TORQUE ADAPTORWITH ANGLE FUNCTION 1/2”Sq.Dr. 20 - 200NmMODEL No: STW291IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGSAND CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURETO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEPINSTRUCTIONS SAFE FOR FUTURE USE.Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to theseinstructions and properly maintained, give you years of trouble free performance.1. SAFETY INSTRUCTIONS3. SPECIFICATION2. INTRODUCTION4. KEYPAD CONTROL FUNCTIONSDesigned for use with a standard ratchet or breaker bar. Idealfor work around the engine bay and the tightening of wheelnuts to factory specifications. Large LCD display with LED/audible alarm indicating achieved and target torque levels.Selectable readings in Nm, lb.ft, lb.in or kg.m. Accurate to±2% of stated capacity and operates in either direction.Features angle mode, eliminating the need forangle gauges and protractors providing the most accurateand fastest way to measure torque plus angle tighteningsequences. Will also accumulate angle measurement whenmultiple turns are required, ideal for use where access isrestricted. Includes auto shut off. Supplied with test certificateand storage case.STW291 Issue No.1 28/06/12Original Language Version© Jack Sealey Limited WARNING! DO NOT use the digital torque adaptor ifdamaged or thought to be faulty. DO NOT apply force to the adaptor when the power isoff. Always turn the adaptor on before using it otherwisethe adaptor will be damaged. DO NOT turn off the torque adaptor while torque force isbeing applied. DO NOT exceed the permitted maximum torque valuefor this torque adaptor. To do so will cause it to break. DO NOT subject the 1/2” connectors on the top andbottom of the adaptor to any force other than a rotationalone. Ensure that all components including all adaptors,extensions, drivers and sockets are rated to match orexceed the torque being applied. Observe all equipment, system and manufacturer’swarnings, cautions and procedures when using thistorque adaptor. Use the correct size socket for the fastener. DO NOT use sockets showing wear or cracks. Check that the torque adaptor capacity matches orexceeds each application before proceeding. Ensure all workshop safety rules, regulations, andconditions are complied with when using this digitaltorque adaptor. Maintain correct balance and footing. Ensure the floor isnot slippery and wear non-slip shoes. Keep children and unauthorised persons away from theworking area. DO NOT press, pressure, or damage the LCD display. DO NOT use the torque adaptor near strong magneticfields . DO NOT subject the digital torque adaptor to excessiveforce or shocks. DO NOT drop or throw the digital torque adaptor. DO NOT leave the digital torque adaptor in any placeexposed to excessive heat, humidity or direct sunlight. DO NOT use organic solvents such as alcohol orthinners to clean the digital torque adaptor. DO NOT submerge the digital torque adapter in water orany other liquid. DO NOT disassemble the digital torque adaptor. To ensure accurate measurement periodic re-calibrationis necessary. After use clean with a soft dry cloth and store in a safe,dry, childproof location.Model No: STW291Drive: “1/2””Sq”Length: 100mmRange: 20-200Nm(15-147.5lb.ft, 354-1770lb.in)Battery: 2 x CR2032 (Supplied)

/ 3

Related manuals for Sealey STW291