Sealey RS1.V3 Instruction Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.IMPORTANT: BEFORE USING THIS PRODUCT, PLEASE READ THE INSTRUCTIONS CAREFULLY. MAKE CAREFUL NOTE OF SAFETY INSTRUCTIONS,WARNINGS AND CAUTIONS. THIS PRODUCT SHOULD ONLY BE USED FOR ITS INTENDED PURPOSE. FAILURE TO DO SO MAY CAUSE DAMAGEAND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. RETAIN THESE INSTRUCTIONS FOR FUTURE USE.2. SPECIFICATIONS1. GENERAL FEATURESIMPORTANT: To reduce risk of battery explosion, follow these instructions and those published by battery manufacturer and manufacturer ofany equipment you intend to use in vicinity of the battery. Remember to review warning marks on all products and on engines.3.1. PERSONAL PRECAUTIONS3 Ensure there is another person within hearing range of your voice, or close enough to come to your aid should a problem arise whenworking near a lead-acid battery.3 Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.3 Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery.3 Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, cleanrunning water for at least 15 minutes and seek immediate medical attention.3 Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit currenthigh enough to weld a ring or the like to metal, which may cause severe burns.3.2. OTHER IMPORTANT SAFETY INSTRUCTIONS3 Familiarise yourself with the application, limitations and potential hazards of the unit.3 Keep the unit in good working order and condition. Take immediate action to repair or replace damaged parts.3 Only use recommended attachments and parts. To use unapproved items may be dangerous and will invalidate your warranty.3 The Roadstart must only be opened and checked by qualified service personnel. DO NOT disassemble for any reason.3 Keep children and unauthorised persons away from the work area.3 Keep work area clean and tidy and free from unrelated materials and ensure that there is adequate lighting.3 If the unit receives a sharp knock or blow, it must be checked by a qualified service agent before being used.3 When not in use re-charge every six (6) months.7 DO NOT smoke or allow a spark or flame in the vicinity of the battery or engine.7 DO NOT drop any metal tool onto the battery as it may spark or short circuit the battery, which could cause an explosion.7 DO NOT use the unit to recharge dry cell batteries that are commonly used with home appliances. These batteries may burst and causeinjury to persons and damage to property.7 DO NOT charge or boost a frozen battery.7 DO NOT allow clamps to touch each other, or to contact the same piece of metal, as this will result in arcing.7 DO NOT use attachments other than those recommended. To do so may risk damage to the unit, equipment and possible injury.GENERAL FEATURES3 Initial peak power RS1.V3 - 1000 amps, RS102.V2 - 1600 amps. More than enough to startmost vehicles. May also be used in DEEP CYCLE applications.3 The Roadstart is also a portable power source for accessories equipped with a male cigarettelighter plug. The DC outlet has automatic 12 amp overload protection.3 Test switch and LED lights. Solid state circuitry.SAFETY FEATURES3 Safety storage holsters prevent accidental sparking of clamps.3 The Roadstart contains the latest technology with its 12 volt sealed lead acid battery. Thismeans the Roadstart RS1 & RS102 may be stored in any position without fear of leakage.IMPORTANT: READ SAFETY INSTRUCTIONS BEFORE ATTEMPTING TO USE THE ROADSTART.Built-in battery . . . . . . . . . . . . . .Sealed lead acid, maintenance free, re-chargeable.DC Output (volts) . . . . . . . . . . . .RS1.V3/RS102.V2 . . . . . . . .12Peak Current (amps) . . . . . . . . .RS1.V3 . . . . . . . . . . . . . .1000. . . . . . . . . . . . . . . . . . . . . . . . .RS102.V2 . . . . . . . . . . . .1600Cold Cranking Current (amps) . .RS1.V3 . . . . . . . . . . . . . . .300. . . . . . . . . . . . . . . . . . . . . . . . .RS102.V2 . . . . . . . . . . . . .600Charging Time . . . . . . . . . . . . . .Up to 30 hours with AC charger.Breaker . . . . . . . . . . . . . . . . . . .12 amp (for DC power port)Weight . . . . . . . . . . . . . . . . . . . .RS1.V3 . . . . . . . . . . . . . .8.2kg. . . . . . . . . . . . . . . . . . . . . . . . .RS102.V2 . . . . . . . . . . . . .9kgDimensions (mm) . . . . . . . . . . . .RS1.V3 . . . . . .335 x 260 x 90. . . . . . . . . . . . . . . . . . . . . . . . .RS102.V2 . . .335 x 235 x 130RS1.V3 & RS102.V2 - 1 - 1912033. SAFETY INSTRUCTIONSpp DANGER! - RISK OF EXPLOSIVE GASES.WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL OPERATION.FOR THIS REASON, IT IS VERY IMPORTANT TO READ AND FOLLOW THESE INSTRUCTIONS EXACTLY EACH TIME YOU USE THE RS1, RS102 or RS2.DC ChargingCableAC ChargingAdaptorI N S T R U C T I O N M A N U A L F O R :PORTABLE ROADSTART UNITSRS1.V3 & RS102.V21) Safety storage holsters2) ëChargedí Indicator light3) Multiple LED power indicator4) Heavy duty thermo-plastic case5) TEST switch6) 12V DC output / charging socket7) Heavy duty clamps8) Flexible heavy duty copper cables9) Wall charger10) DC charging / output cable

/ 3

Related manuals for Sealey RS1.V3