Sealey SFC01 Quick Start Manual

SUBFRAME/ENGINE LOAD ADAPTOR FORTTJ TRANSMISSION JACKSMODEL NO: SFC01Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditionsand situations that may occur. It must be understood that common sense and caution are factors which cannot be built into thisproduct, but must be applied by the operator. WARNING!Ensureallpreliminarychecksarecarefullycarriedoutbeforeuseandthatallfixingsarecorrectlyandsecurelyengaged.Immediately repair or replace damaged parts (use authorised service agent). Ensure use of genuine parts only.Unauthorised parts may be dangerous and will invalidate the warranty. WARNING!Usejackonlevelandsolidground,preferablysmoothconcrete.Ensuretheflooroverwhichtheloadedjackwillbetransported is swept clean. WARNING!Ensurethattheloadeditemiscorrectlysupported,wellbalancedandsecuredinplacepriortofinalremovalfromvehicleand before any movement of the loaded jack within the workshop.8 DO NOT make any modifications to the unit supplied.▲ DANGER! DO NOT use on tarmacadam, or any other soft surface as jack may sink or topple. Serious injury may result if ignored.▲ DANGER! If the load tips or leans, stop what your are doing. MOVE QUICKLY TO A SAFE DISTANCE. DO NOT TRY TO HOLDOR STEADY JACK.9 The unit is intended for use only with Sealey products 500TTJ and 800TTJ.9 Ensure that load adaptor is correctly attached to the jack and that the grub-screw is fitted before use.2. INTRODUCTIONFully adjustable SFC01 Subframe/Engine support adaptor that is supplied with various designs of fittings to suit different applications.Designed to assist in the removal and fitting of subframes, complete engine assemblies, rear axles, gearboxes, fuel tanks, exhaust systemsand other awkward loads. The adaptor easily fits directly on to the Sealey 500TTJ and 800TTJ Transmission Jacks and assists in allowingawkward two or three man jobs to be carried out by one person.3. SPECIFICATIONModel No.:.................................................................. SFC01Capacity ....................................................................... 450kg4. ASSEMBLY4.1. Thread the boss located on the underside ofthe Load Plate onto the Jack ram. Fix in placeusing the grub screw supplied when fullyengaged.4.2. ThreadM16StudandHexnut(fig.1)intoloadplate such that underside of the nut restson the surface of the Load Plate and that thestud is flush with the nut.4.3. Slide the Support arm guide over the stud andscrew the Support arm hand wheel onto it.4.4. Screw the Tool post and hand wheel assemblyinto the Support arm.M16 Stud barand Hex. nutTool post andHand wheelSupport armHand wheelSupport armGuideSFC01 Issue 1 12/01/22Original Language Version© Jack Sealey LimitedRefer toinstructionsWear protectiveglovesWear safetyfootwearLoad Platefig.1

/ 2

Related manuals for Sealey SFC01