Sealey PP4.V2 Instructions Manual

Also see for PP4.V2: Instructions Instructions Instructions

Detector TransmitterOperating Conditions: 0°C ~ 40°C <80% RH 0°C ~ 40°C <80% RHFrequency Response: 40kHz +/- 2kHz -Output Frequency: - 40kHzBattery: 9V 9VSize: 192 x 50 x 30mm 80 x 56 x 27.5mmWeight: 115g (incl battery) 75g (incl battery)1.1. GENERAL SAFETY INSTRUCTIONS1.1. Familiarise yourself with the application, limitations and potential hazards of the tester. Also refer to the vehicle manufacturer’s handbook.1.2. Ensure that the tester is in good condition before use.1.3. Only use recommended attachments and parts. To use unapproved items may be dangerous and will invalidate your warranty.1.4. If the tester receives a sharp knock or blow the unit must be checked by a qualified service agent before using.1.5. Keep children and unauthorised persons away from the work area. DO NOT disassemble the tester for any reason. The tester must only be checked by qualified service personnel. WARNING! To avoid damaging hearing, DO NOT set headphones volume too high. DO NOT drop the detector or transmitter. DO NOT tamper with the electronic circuit boards within the dectector or transmitter. DO NOT use the tester outdoors, or in damp, or wet locations and DO NOT use in the vicinity of flammable liquids or gases. DO NOT use the dectector or transmitter near any electrical appliances which emit electromagnetic waves, as this will give a falsereading. DO NOT use the tester for a task for which it is not designed.1.6. When not in use, store the tester carefully in a safe, dry, childproof location.1.7. If the dectector and transmitter are not to be used for long periods, remove the batteries before storing.InsTRuCTIOns FOR:ULTRASONIC LEAk DETECTORmOdEl no: PP4.V2Thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions andproperly maintained, give you years of trouble free performance.1. SAFETY INSTRUCTIONS2. INTRODUCTION & SPECIFICATIONQuick and simple location of air, water or dust leaks. Place the transmitter in the vehicle and close the doors and windows. Trace the detectoraround outside of the screen, windows and door seals to locate the leak. Includes adjustable headphones for detector. Transmitter anddetector powered by 9V batteries. supplied in carry-case.PP4.V2 Issue no: 3(I) - 14/03/16Original Language Version© Jack sealey limitedRefer toInstructionmanualIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

/ 3

Related manuals for Sealey PP4.V2