Sealey AP12600.V4 Instructions Manual

Also see for AP12600.V4: Instructions

Workstation 1.2m With DraWersModel no: aP12600.V4thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.imPortant: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. safety WarninG! ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this bench.9 locate bench in a suitable work area.9 Keep the work area clean, uncluttered and ensure there is adequate lighting. WarninG! Use bench on level and solid ground, preferably concrete.9 Keep the bench clean and tidy in accordance with good workshop practice.9 Keep children and unauthorised persons away from the work area.8 Do not use the bench for any purpose other than that for which it is designed.8 Do not undertake work on the bench without the workpiece being adequately secured. Use clamps or a vice (not included) to securethe workpiece - available from your Sealey Stockist.8 Do not use the bench outdoors .8 Do not get the bench wet or use in damp or wet locations or areas where there is condensation.8 Do not exceed the maximum load for the work surfaces, worktop and bottom shelf - 100kg each, top shelf - 20kg. Avoid heavyimpacts when placing objects onto the surfaces.8 Do not clean the bench with any solvents which may damage the surface or the protective coating on the worktop.2. introDuctionBoltless designed frame makes the unit easy to assemble, with minimal tools being required. Pegboard rear panel with hooks for convenienttool storage. Two half drawers, with ball bearing slides, full size shelf below MdF worktop and 230mm shelf above pegboard.3. sPecificationModel no: .................................................................................... AP12600nett Weight: ..................................................................................... 33.9kgSize (W x d x H [overall/Worktop]): .....................1215 x 610 x 1500/900mmWorktop: ................................................................................. 1205 x 600mmAP12600.V4 Issue 2 06/02/19Original Language Version© Jack Sealey limitedRefer toinstructionsWear protectivegloves

/ 4

Related manuals for Sealey AP12600.V4