Samsung SPE-400 User Manual

Also see for SPE-400: User manual

setup screenTo make recording on the SD memory1. Check the memory card’s <Free> size and <Total> size.2. If there are sufficient free space, set the device to <On>.Otherwise, check the stored data and if you find them not important, then click<Format> to format the SD memory. Some frames may be skipped if the SD memory card operates at the lower speed than recommended.For more details, refer to “Recommended SD/SDHC Memory Card Specifications”. (Page 10) For a SD memory card with a large capacity, the formatting will be slowed down accordingly. The data traffic will increase when the encoder is set to higher resolution, higher bit rate, and/or higherframerate.If there is too much data traffic, some frame may be skipped although it is stored in a full frame.3. Specify the storage action. Record profile : Shows recording profile’s codec type. Overwrite : If the SD memory is full, this will delete old data and store new data inreplacement. Pre-alarm duration : Specify the time point before the occurrence of the alarm;starting from the time point, the images will be transferred. You can specify up to5 seconds before the occurrence of the alarm. Post-alarm duration : Specify the time point after the occurrence of the alarm; tothe specified time point, the images will be transferred. You can specify up to 120seconds after the occurrence of the alarm. Normal : Make recording at a certain frame rate. Event : Set the recording type for a certain event that occurs.4. Specify the <Normal record setup>. Always : Always save recorded video in the SD memory card. If set to Always, the activation time cannot be changed. Only scheduled time : Records only on the specified time of the specified day of week. [Clear ( )] : Reset all settings.5. When done, click [Apply ( )].70_ setup screen