Samsung ML-2550 Series User Manual

Also see for ML-2550: Product guide Solution guide User guide Manual Del Usuario Manual

Contents

supported sizes of paper

USING YOUR PRINTER ON A NETWORKE.106 Press the scroll button ( or ) to display “Yes” andpress the Enter button ( ).7 Press the Upper Level button ( ), then use the scrollbutton ( ).8 Press the Enter button ( ) when “IP Get Method”displays.9 Press the scroll button ( or ) to display “DHCP” andpress the Enter button ( ).10 To assign the address from the BOOTP server, press theEnter button ( ) when “BOOTP” displays.11 Press the ON Line/Continue button ( ) to return toready mode.Configuring IPX Frame TypesOn IPX/SPX protocol networks (for example, Novell NetWare),the format of network communication frames must be specifiedon the printer. In most cases, you can keep the default setting“AUTO”. However, you can manually set the frame type format,if required.• AUTO (default): Automatically senses and limits the frametype to the first one detected.• EN_8023: Limits the frame type to IPX over IEEE 802.3frames. All others will be counted and discarded.• EN_II: Limits the frame type to IPX over Ethernet Frames.All others will be counted and discarded.• EN_8022: Limits the frame type to IPX over IEEE 802.2 withIEEE 802.3 frames. All others will be counted and discarded.• EN_SNAP: Limits the frame type to IPX over SNAP with IEEE802.3 frames. All others will be counted and discarded.Note that the IPX/SPX protocol must be enabled in the Netwaremenu before you can configure frame types. See “SettingNetwork Protocols” on page E.7.