Samsung HT-FS6200/XU User Manual

Also see for HT-FS6200: User manual

English 25 |04 Settings5. On the Security type screen that appears, use the▲▼ buttons to select the network's Security type,and then press the E button. On the next screen,enter your network's security code or pass phrase.• Enter numbers directly using the number buttonson your remote control.• Enter letters by selecting a letter with the ▲▼◄►buttons, and then pressing the E button.When finished, select Done, and then press the Ebutton. The product searches for the network.6. The Network connection fail screen appears. Use◄► buttons to select IP Settings, and then pressthe E button.7. Select the IP setting field, and then set it to Entermanually.8. Select a network value to enter (IP Address, forexample), and then press E button. Use thenumber keypad on your remote control to enter thenumbers for the value. You can also enter numbersusing the ▲▼ buttons. Use the ◄► buttons on theremote control to move from entry field to entry fieldwithin a value. When done with one value, press theE button.9. Press the ▲ or ▼ button to move to another value,and then enter the numbers for that value followingthe instructions in Step 8.10. Repeat Steps 8 and 9 until you have filled in allvalues.| NOTES | You can get the Network values from your Internetprovider.11. When finished, select OK, and then press the Ebutton. The Security Screen appears.12. On the Security screen, enter your network'sSecurity Code or Pass Phrase. Enter numbersdirectly using the number buttons on your remotecontrol. Enter letters by selecting a letter with the▲▼◄► buttons, and then pressing the E button.13. When finished, select Done at the right of thescreen, and then press the E button. The productverifies the network connection and then connectsto the network.14. After the home cinema verifies the network, selectOK, and then press the E button.| NOTES | You can also begin the Manual Network setting bygoing to Settings >Network > Network Status. WPS(PBC)One of the easiest ways to set up the wireless networkconnection is using the WPS(PBC) function. If yourwireless router has a WPS(PBC) button, follow thesesteps:After following Steps 1 to 3 in "Configuring Your NetworkConnection" on page 23:1. In the Network Settings screen, change Networktype to Wireless. The product searches for andthen displays a list of the available networks.2. Scroll the list down, select WPS(PBC), and thenpress the E button.3. Press the WPS(PBC) button on your router withintwo minutes. Your product automatically acquires allthe network settings values it needs and connectsto your network.The product connects to the network after thenetwork connection is verified.4. When it is done, highlight OK, and then press Ebutton.| NOTES | For WPS connection, set your wireless router’ssecurity encryption to AES. Setting to WEP securityencryption does not support WPS connection.Wi-Fi DirectThe Wi-Fi Direct function allows you to connect Wi-FiDirect devices to the product and each other using apeer-to-peer network, without a wireless router.| NOTES | Some Wi-Fi Direct devices may not support theAllShare function if connected via Wi-Fi Direct. If this isthe case, change the network connection method youused to connect the device to the home cinema. Wi-Fi Direct transmissions can interfere with theBluetooth signal. Before you use the Bluetoothfunction, we strongly recommend that you turn offthe Wi-Fi Direct function on any device in which it iscurrently on.1. Turn on the Wi-Fi direct device and activate its Wi-FiDirect function.2. In the Home screen, select Settings, and thenpress the E button.3. Select Network, and then press the E button.4. Select Wi-Fi Direct, and then press the E button.The Wi-Fi Direct devices that you can connectappear.