EnglishTroubleshootingEnglish50Information codesIf the dryer fails to operate, you may see an information code on the screen. Check the table below and trythe suggestions.Information code Meaning ActionDoor is open Dryer operation with the dooropen• Close the door and start again.• If this continues, call for service.• Check if Child Lock is on. If Child Lock ison, you may get this message when youopen the door even though the dryer is notoperating.Open door & checkinside (Child Lockon)Child Lock is on. Open the doorand check inside the drum.• If Child Lock is on, turn off Child Lock or thepower.Check filter Lint filter problem • Check the lint filter assembly.• If this continues, call for service.Check inner coverof heat exchangerInternal heat exchanger coverproblem• Check the internal heat exchanger coverassembly.• If this continues, call for service.Check drainage /Empty the tankDraining malfunctionDraining pump malfunctionFrozen draining hoseWater tank full• Make sure the draining hose is not bent ordamaged.• If the hose is frozen, wrap the hosewith a towel soaked in warm water forapproximately ten minutes to thaw thehose.• Empty the water tank, turn on the dryer, andstart again.• If this continues, call for service.tC Air temperature sensor problem • Clean the lint filter or the heat exchanger.• If this continues, call for service.tC5 Compressor temperature sensorproblem• Wait two to three minutes.• Turn the power back on and start again.tC7 Check the Eva In temperaturesensor• Turn the power back on and start again.• If this continues, call for service.tC8 Check the Eva Out temperaturesensor• Turn the power back on and start again.• If this continues, call for service.tCA Check the Compressor Toptemperature sensor• Turn the power back on and start again.• If this continues, call for service.3C Check the motor for operation. • Try restarting the cycle.• If this continues, call for service.U-PJT_DRYER_SimpleUX_WEB_DC68-04169H-02_AU_English.indd 50 2021/11/3 17:33:44