Wired - ManualIf you have a static IP address or the Automatic procedure does not work, you'llneed to set the Network Settings values manually.Follow Steps 1 and 2 in Wired - Automatic and then follow these steps:1. Select Network Status. The product searches for a network, and then displaysthe connection failed message.2. On the bottom of the screen, select IP Settings, and then press the E button.The IP Settings screen appears.3. Select the IP Setting field, and then press the E button.4. Select Enter manually in the IP Setting field, and then press the E button.5. Select a value to enter (IP Address, for example), and then press the Ebutton. Use the number keypad on your remote control to enter the numbersfor the value. You can also enter numbers using the ▲▼ buttons. Use the ◀▶buttons on the remote control to move from entry field to entry field within avalue. When done with one value, press the E button.6. Press the ▲ or ▼ button to move to another value, and then enter the numbersfor that value following the instructions in Step 5.7. Repeat Steps 5 and 6 until you have filled in all values." You can get the Network values from your Internet provider.8. When finished entering all the values, select OK, and then press the E button.The product verifies the network connection and then connects to the network.
