5.12 CHAPTER FIVE : VCR OPERATIONV C R O P E R AT I O N▼12Press the MENU button toexit the menu system andreturn to normal viewing.To enter additional programrecording times, repeat steps 1-11.If you enter two program times thatoverlap, a program overlap warningappears on the TV screen, along withinstructions for fixing the overlap.The timer indicator on the front panelof the TV illuminates when programtimes have been stored.The TV should be turned off torecord the programs you’ve chosen.13Press the POWER buttonto turn off the VCR.IMPORTANT:• The TV should be off to record the programs you’ve chosen. But, if you are recordinga channel that comes through a cable box, be sure to leave the cable box turned onand tuned to the channel you want to record.• When a timer recording is in progress, there is no picture on the monitor because thepower is off. If you want to watch the channel while it's being recorded, press POWERon the remote control only.• One-time timer programs clear from memory automatically when the recording isfinished. Daily and weekly programs remain in the timer until you remove them.If power to the TV is interrupted,timer program will be removed from memory.The clock and calendar, however, must be reset.11Press the UP/DOWN▲▼button to select “Mode”,then press theUP/DOWN▲▼ buttons toselect “Once”, “Wkly”, or“Dly”.▼ For more information onselecting tape speeds, see pages 5.6,5.7, and A.2.10Press the UP/DOWN▲▼button to select “SPEED”,then press theLEFT/RIGHT œœ√√ buttonsto select speed at whichyou want to record.03233A(E)-CHAPTER 5 12/9/03 10:09 AM Page 12
