English - 4Setting up the TV with your PCPreset: Press the SOURCE button to select PC mode.1. Press the MENU button to display the menu.Press the ▲ or ▼ button to select “Picture”, then press the ENTERbutton.2. Press the ▲ or ▼ button to select “Auto Adjustment” or “Screen Adjustment”,then press the ENTER button.3. When you are satisfied with your setting, press the ENTER button.4. Press the EXIT button to exit.How to Auto AdjustAuto Adjustment allows the PC screen of set to self-adjust to the incoming PCvideo signal. The values of fine, coarse and position are adjusted automatically.This function does not work in DVI-HDMI mode.Easy Setting1. Press the TOOLS button on the remote control.2. Press the ▲ or ▼ button to select “Auto Adjustment”, then press the ENTERbutton.Adjusting the Screen QualityCoarse/FineThe purpose of picture quality adjustment is to remove or reduce picture noise. Ifthe noise is not removed by Fine-tuning alone, then adjust the frequency as bestas possible (coarse) and Fine-tune again. After the noise has been reduced,readjust the picture so that it is aligned on the center of screen.Press the ▲ or ▼ button to select “Coarse” or “Fine”, then press the ENTERbutton.Press the ◄ or ► button to adjust the screen quality.Press the ENTER button.PositionAdjust the PC’s screen positioning if it does not fit the TV screen.Press the ▲ or ▼ button to adjusting the Vertical-Position.Press the ◄ or ► button to adjust the Horizontal-Position.Press the ENTER button.Image ResetYou can replace all image settings with the factory default values.➣➣Brightness : 45Sharpness : 50Auto Adjustment ►Screen AdjustmentDetailed SettingsPicture OptionsPicture ResetPictureAuto Adjustment in progress. Please Wait.Screen AdjustmentCoarse 52Fine 24PositionImage ResetEnterMove ReturnScreen AdjustmentCoarse 52Fine 24PositionImage Reset ►EnterMove ReturnImage Reset is completed.TOOLSDevice ListPicture Mode : StandardSound Mode : CustomSleep Timer : OffSRS TS XT : OffPIPEnergy Saving : OffAuto AdjustmentMove Enter e ExitPositionReturnEnterAdjust
