Pcs. Component name1 Motherboard2 Weighing module3 Round ferrite core4 Ferrite core4. While installing the module in the plastic socket on the main board turnyou attention to the position of the module (see the figure below),5. The strain gauge cable led through additional gland PG7 situated on theback wall next to the gland of the main platform cable;6. Pull a ferrite core on the cable (appropriate internal diameter);7. Wind wires of the cable on the round ferrite core (5 coils);8. The wires solder accordingly to pads on the PCB. USE A SOLDERINGIRON (not a solder gun with a transformer);9. Connect cable IN/OUT to group of conductors (undo band clips fasteninggroup of conductors, lay the cable and clamp band clips – multiple useband clips);10.Assembly cover of indicator casing.34.2. Additional 8 inputs / 8 outputs module8 inputs / 8 outputs PCB - WE 8This module can be connected inside the weighing terminal. Its task isto expand the functionality of terminal for 8 inputs and 8 outputs freelyconfigurable.- 122 -
