14 – Command ReferenceSet Config Threshold14-96 59183-03 ASSet Config ThresholdSets the port alarm threshold parameters by which the switch monitors portperformance and generates alarms. The changes you make with this commandare not retained when you reset or power cycle the switch unless you save themusing the Config Save command.Authority Admin session and a Config Edit sessionSyntax set config thresholdInitiates a configuration session by which to generate and log alarms for selectedevents. The system displays each event, its triggers, and a sampling window oneline at a time and prompts you for a value. For each parameter, enter a new valueor press the Enter key to accept the current value shown in brackets. Table 14-23describes the port alarm threshold parameters.Table 14-23. Port Alarm Threshold ParametersParameter DescriptionThreshold Monitoring Enabled Master enable/disable parameter for all events.Enables (True) or disables (False) the generationof all enabled event alarms. The default is False.CRCErrorsMonitoringEnabledDecodeErrorsMonitoringEnabledISLMonitoringEnabledLoginMonitoringEnabledLogoutMonitoringEnabledLOSMonitoringEnabledThe event type enable/disable parameter. Enables(True) or disables (False) the generation of alarmsfor each of the following events: CRC errors Decode errors ISL connection count Device login errors Device logout errors Loss-of-signal errorsRising Trigger The event count above which a rising trigger alarmis logged. The switch will not generate another ris-ing trigger alarm for that event until the countdescends below the falling trigger and againexceeds the rising trigger.Falling Trigger The event count below which a falling trigger alarmis logged. The switch will not generate another fall-ing trigger alarm for that event until the countexceeds the rising trigger and descends againbelow the falling trigger.Sample Window The time in seconds in which to count events.
