Qlogic SANbox 5600 Series Interface Manual

Also see for SANbox 5600 Series: Brochure Supplementary guide Supplementary guide Guidelines Supplementary guide

Contents

Qlogic SANbox 5600 Series Interface Manual Manual pdf 132 page image

9 – Device Security ConfigurationResetting the Security Database9-10 59183-03 ASResetting the Security DatabaseThere are two ways to remove all groups and security sets from the securitydatabase: Enter the Security Clear command as shown in the following example:SANbox (admin-security) #> security clearAll security information will be cleared. Please confirm (y/n): [n] ySANbox (admin-security) #> security save Enter the Reset Security command as shown in the following example. Thesecurity configuration values, autosave and fabric binding remainunchanged.SANbox (admin) #> reset securityManaging Security SetsManaging Security Sets consists of the following tasks: Create a Security Set Delete a Security Set Rename a Security Set Copy a Security Set Add Groups to a Security Set Remove Groups from a Security Set Activate a Security Set Deactivate a Security SetAll of these tasks except Activate a Security Set and Deactivate a Security Setrequire a Security Edit session.Create a Security SetEnter the Securityset Create command to create a new security set as shown inthe following example:SANbox (admin-security) #> securityset create securityset_1Delete a Security SetEnter the Securityset Delete command to delete a security set as shown in thefollowing example:SANbox (admin-security) #> securityset delete securityset_1