12 – Call Home ConfigurationManaging the Call Home Database12-6 59183-03 ASEnter the Show Setup Callhome command to display the Call Home serviceconfiguration as shown in the following example.SANbox #> show setup callhomeCallhome Information--------------------PrimarySMTPServerAddr 0.0.0.0PrimarySMTPServerPort 25PrimarySMTPServerEnabled FalseSecondarySMTPServerAddr 0.0.0.0SecondarySMTPServerPort 25SecondarySMTPServerEnabled FalseContactEmailAddress nobody@localhost.localdomainPhoneNumber StreetAddress FromEmailAddress nobody@localhost.localdomainReplyToEmailAddress nobody@localhost.localdomainThrottleDupsEnabled True+ indicates active SMTP serverManaging the Call Home DatabaseTo modify the Call Home database, you must open an Admin session with theAdmin Start command. An Admin session prevents other accounts from makingchanges at the same time through Telnet, QuickTools, Enterprise Fabric Suite2007, or another management application. You must also open a Callhome Editsession with the Callhome Edit command. The Callhome Edit session providesaccess to the Callhome, Capture, and Profile commands with which you makemodifications to the Call Home database.SANbox #> admin startSANbox (admin) #> callhome editSANbox (admin-callhome)#> callhome . . .SANbox (admin-callhome)#> profile . . .SANbox (admin-callhome)#> capture . . .When you are finished making changes, enter the Callhome Save command tosave the changes and close the Callhome Edit session. Changes take effectimmediately.SANbox (admin-callhome)#> callhome saveTo close the Callhome Edit session without saving changes, enter the CallhomeCancel command.SANbox (admin-callhome)#> callhome cancel
