Pioneer SGY-PM910ZWL User Manual

25EN Pairing /CalibrationPairing with the Cyclocomputer6. Tap [Search].The search for the sensor starts.A [Searching. Please wait.] messageappears.7. Check the information aboutthe sensor.Information about the sensors appearswhen the sensors are found.Check the following items.• [Device Number]Make sure that the device numberis the same as the device numberof the transmitter.• [Error Rate]Make sure that “OK” is displayed.• The device numbers are printed onthe right junction box and on the sideof the left sensor. If the numbers thatare displayed on (Page 7)[DeviceNumber] are different from thetransmitter device numbers, specifythe device numbers to pair with thesensor. Refer to the User's Guide(For WEB) of the CyclocomputerSGX-CA500 regarding how tospecify a device number to pair asensor.• If “Processing...” is displayed in the[Error Rate] area, the informationfrom the sensor is not being receivedcorrectly because transmissionconditions are bad. Make surethat the sensor you are pairing isactivated, then bring the SGX-CA500closer to the sensor and perform thepairing operation again.• Pairing with the sensor may notbe possible due to interferencein the same frequency band. If“Processing...” is displayed even ifthe SGX-CA500 is moved closerto the sensor and paired with it, tryagain someplace where there is nointerference from microwaves, radiowaves, or wireless equipment.Pairing of the right transmitter iscompleted. Pair the left transmitter inthe same way.