Pioneer SGY-PM910ZWL User Manual

17EN Getting StartedSwitching to the pedaling monitor mode• [Success]Mode is switched.• [Timeout]Sensor is not found.• [Cancel]Cancel is pressed.• [Low Battery]The battery is almost empty.• Timeout: Communication status islikely to be poor. Sensor informationcannot be received properly. Makesure that the sensor you are pairingis activated, then bring the SGX-CA500 closer to the sensor andperform the pairing operation again.Pairing with the sensor may not bepossible due to interference in thesame frequency band. If “Timeout”is displayed even by operatingafter moving SGX-CA500 closer tothe sensor and pairing with it, tryagain someplace where there is nointerference from microwaves, radiowaves, or wireless equipment.• Low Battery: The battery is almostempty. Remove the battery andreplace with a new one. For howto install/remove batteries, refer toPage 12.If you do not add the sensor in thesensor list, the SGX-CA500 will notpair with the sensor.You can add the sensor in the sensorlist later, using the [Sensors] menu.When the mode is switched, theLEDs of the sensors light green for 10seconds.Add in the sensor list of SGX-CA500When it is added in the sensor list,it pairs with SGX-CA500. Hereafter,whenever the sensor is started, it willautomatically pair with SGX-CA500.To confirm the sensor list, press themenu button on the left of the producton the main screen of the CycloMeterand tap [Sensors]. The display on themode switching completion screen isas follows depending on the status.