Pioneer PRA-BD11 Operating Instructions Manual

Also see for PRA-BD11: Supplementary guide Service manual

17PRA-BD11 / PRA-BD12EnEnglish14. Install the input terminal cover (or output terminal cover) on the rear panel.÷ Secure the input terminal cover (or output terminal cover) supplied with the unit tothe DVD recorder rear panel using the black screws removed in Step 2. First tightenscrew 1 and then screw 2.Note:Install the input terminal cover on the left expansion slot (as seen from the rear) (see thesection “Name of Parts” in the DVD recorder Operating Instructions). The output terminalcover is installed in the right expansion slot (as seen from the rear).12Expansion slots on therear of the DVD recorderInput terminal cover (or output terminal cover)Installation15. Reinstall the top panel (PRV-LX1).÷ Use the seven screws removed inStep 1.Note:Check that the FFC cables and the 4-pincables are connected to the PRA-BD11input board and the PRA-BD12 outputboard before installing the top panel.Top panelCover panel÷ Reinstall using the nineteen screwsremoved in step 1. Fasten the screwsin the specific order a - b on the rearsurface, followed by the sevenscrews in the top side, four on theright side, four on the left side, andthe final two on the rear surface.Note:Check that the FFC cables and the 4-pincables are connected to the PRA-BD11input board and the PRA-BD12 outputboard before installing the top panel.15. Reinstall the cover panel (PRV-LX10).