1599) Setting the OSD displayThis function suppresses the OSD display (INPUT display, etc.) in normal operating mode.Even while OSD is OFF, the following OSD displays are possible.1 MENU display (menu mode and integrator mode)2 Warning just prior to AUTO POWER OFF or power management function operation3 Warning from self-diagnosis function when interior temperature of set has become high4 Announcements while KEY LOCK is in effect and KEY LOCK/UNLOCK setting displays5 Display calls (including)When OSD display is not necessary, owing to automatic running directions and the like = select OFF.Factory preset : ON1 Enter integrator mode.(See 5.4.1, “About the integrator mode.”)The set ID will be displayed on the upper right where the“– –“ mark is.Select OPTION.2 Move the cursor to OSD and use the SET button to changethe setting.Each time the SET button is pressed, the setting will changebetween ON and OFF.OSD applies to all inputs (INPUT1~5).Screen 1Screen 2Integrator Mode]]OD :::::::::A AS DEMTTBOURNOFFO FFO F /FO FFO FFONERLU A KSFSLEIDIMA KSMO EDMO EDMO EDM O EDMA KSM LO TENTORIOBR RCEN S ERICVOLOR4 8 B0 01 2 8 / 112 8 1 2 8/1 0/ 0. W/P SI NPUT 1––I NTEGRATOR MENUCHANGE EXITMENUSETSELECTPICTURE WHITE BAL SCREEN SET UP OPTIONOD :::::::::A AS DEMTTBOURF FOFFO FFO F /FO FFO FFONERLU A KSFSLEIDIMA KSMO EDMO EDMO EDM O EDMA KSM LO TENTORIOBR RCEN S ERICVOLOR4 8 B0 01 2 8 / 112 8 1 2 8/1 0/ 0. W/P SI NPUT 1––I NTEGRATOR MENUCHANGE EXITMENUSETSELECTPICTURE WHITE BAL SCREEN SET UP OPTION
