1121) Installing procedurePerform installation according to the following steps (1)to (3).Note:After this unit has been installed on the plasma dis-play, you can’t use the display operation panel. Pleaseuse the remote control supplied with the display.(1) Attach the mounting plates to this unitAs in the illustration below (right speaker only), when look-ing from the rear, attach the right mounting plate to theright hand side of the right speaker. For the left speaker,attach the left mounting plate to ther left hand side.(3) Install this unit on the display sideInstall the unit marked "RIGHT" on the right side of thedisplay.(2) Install the mounting fittings on this unitThe illustration shows an example for this unit (right side).Install the unit marked "LEFT" on the left side of the dis-play.1 Check the indications LEFT and RIGHT at the rear of thespeakers, observe the indication "UP»", and fasten the uppermounting fitting provisionally to the display. Then install thelower fitting on the display.2 Adjust the position so that the gap between the speaker andthe display is uniform, and then tighten the screws firmly.Speaker System: PDP-S05-LRNote• When the display is to be moved after speakerinstallation, do not hold the display by the speakers.Hold the bottom of the display to move it.Adjust the mounting plate to about 0.5 cmbelow the upper edge of the speaker.SealMounting plate1 Match the speakers and themounting plates so that the correctcombination of left and right isobtained.2 Peel the seals from the adhesivesurfaces of the mounting plates.3 Confirm the installation position andattach the mounting plate to theinside of the speaker.SealMounting plateSealFor top sideMounting plateFlat countersunkhead screwFor bottom1 The top side fittings aredifferent for the right and theleft side, and they must bematched correctly.2 Install the mounting fittingswith bolts at the positionsshown in the figure on the left.Hexagon sockethead screwPlasma displayHexagon sockethead screwPlasma display4.12.3 Installation on the PDP-503CMX or PDP-503MXE[503CMX/503MXE]
