Before you start0428En1 Connect the microphone to the MCACC SETUPMIC jack on back of the display unit.2 Place the microphone at your normal listeningposition.Place it about ear height, and make sure it is level byusing a table or chair.Make sure there are no obstacles between the speakersand the microphone.3 If the receiver subwoofer is off, pressSYSTEM ON to turn the power on.4 Press SYSTEM CONTROL to set the remotecontrol to receiver control mode.Make sure that the LCD displays the SYSTEM screen, asshown below.5 Press MCACC.Try to be as quiet as possible after pressing MCACC. Thevolume increases automatically and the system outputsa series of test tones.• To cancel Auto MCACC setup before it has finished,press MCACC. The unit will continue to use theprevious settings.• If the ambient noise level is too high, Noisy! blinks inthe display for five seconds. To exit and check thenoise levels1 , press MCACC, or to try again, pressENTER when Retry shows in the display.• If you see an Error MIC! or Error Speaker! messagein the display, there may be a problem with your micor the speaker connections. To try again, pressENTER2 .When the MCACC setup is complete, the volume levelreturns to normal, Complete3 shows in the display, andMCACC Effect is activated. 4• Be sure to disconnect the microphone from this unitupon completion of the Auto MCACC setup.F.AUDIODISPLAY UNITiPod MCACCSETUP MICSYSTEMONSYSTEMCONTROLSYSTEMSURR ADV.SURR F.S.SURRNote1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking thespeakers from the microphone) the final settings may be incorrect. Check for household appliances (air conditioner, fridge, fan, etc.), that maybe affecting the environment and switch them off if necessary.• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during Auto MCACC setup.2 If this doesn’t work, press MCACC, turn off the power, and check the problem indicated by the Error message, then try the Auto MCACC setupagain.3 If Complete doesn’t appear, it is likely an error occurred during the setup. Please check all connections and try again.4 See Listening with MCACC Effect on page 34 to switch on/off MCACC Effect.MCACC
