En 9Englishq CUE/LOOP CALLc/d (page 16), DELETE (page 16), MEMORY(page 16)r VINYL SPEED ADJUST RELEASE/START (page 17)s JOG ADJUST (page 17)t JOG MODE, VINYL mode indicator and CDJ mode indicator(page 17)The mode switches between VINYL and CDJ each time this is pressed. Theindicator for the selected mode lights.u TEMPO ±6/±10/±16/WIDE (page 14)v MASTER TEMPO (page 14)w TEMPO (page 14)x TEMPO RESET and TEMPO RESET indicatorRegardless of the position of the TEMPO dial, tracks are played at theoriginal playing speed recorded on the disc, etc. The indicator lights whenTEMPO RESET is turned on.y Jog dial (– REV/+ FWD) and JOG RING ILLUMINATION (page 17)z Jog dial display section (page 10)Rear PanelA POWER wON vOFFPress to turn the power on and off.B AUDIO OUT L/R (page 11)C AC IN (page 11)D CONTROL (page 18)E DIGITAL OUTF Kensington security slotG LINK (page 11)H USB (page 11)Front PanelI Disc insertion slotJ Disc force eject pin insertion holeK Disc insertion slot indicatorAbout ejecting discs by force! If the disc cannot be ejected by pressing [DISC EJECTh], the disc can beejected forcibly by inserting the disc force eject pin all the way into the discforce eject pin insertion hole on the main unit’s front panel.! When forcibly ejecting a disc, be sure to do so following the procedure below.1 Press [POWER] and wait at least 1 minute after the set’spower has turned off.Never forcibly eject a disc directly after turning off the set’s power. Doing so isdangerous for the reasons described below.The disc will still be spinning when ejected and could hit your fingers, etc.,causing injury.Also, the disc clamp will rotate in an unstable way, and the disc could getscratched.2 Use the included disc force eject pin. (Do not use anythingelse.)The included disc force eject pin is mounted on the CDJ-2000’s bottom panel.When the pin is inserted all the way into the insertion hole, the disc is ejected5 mm to 10 mm out of the disc insertion slot. Grasp the disc with your fingers andpull it out.
