1 Touch A.MENU and AUDIO and thentouch LOUDNESS.2 Touch a to turn loudness on.# To turn loudness off, touch b.3 Touch c or d to select a desired level.Each time you touch c or d selects level inthe following order:LOW (low)MID (mid)HIGH (high)Using subwoofer outputThis unit is equipped with a subwoofer outputwhich can be turned on or off.! When the subwoofer output is on, you canadjust the cut-off frequency and the outputlevel of the subwoofer.1 Touch A.MENU and AUDIO and thentouch SUB WOOFER.# When the subwoofer controller setting isPREOUT FULL, you cannot select SUB WOOFER.2 Touch d to turn subwoofer output on.# To turn subwoofer output off, touch c.3 Touch b and then touch c or d to se-lect the phase of subwoofer output.Touch d to select normal phase andNORMAL appears in the display. Touch c toselect reverse phase and REVERSE appears inthe display.4 Touch b and then touch c or d to ad-just the output level of the subwoofer.Each time you touch c or d increases or de-creases the level of the subwoofer. +6 6 isdisplayed as the level is increased or de-creased.5 Touch b and then touch c or d to se-lect cut-off frequency.Each time you touch c or d selects cut-off fre-quencies in the following order:5080125 (Hz)Only frequencies lower than those in the se-lected range are output from the subwoofer.Using non fading outputWhen the non fading output setting is on, theaudio signal does not pass through this unitslow pass filter (for the subwoofer), but is out-put through the RCA output.1 Touch A.MENU and AUDIO and thentouch NON FADING.# When the subwoofer controller setting is onlyPREOUT FULL, you can select NON FADING.(Refer to page 81.)2 Touch a to turn non fading output on.# To turn non fading output off, touch b.3 Touch c or d to adjust the output levelof the non fading.Each time you touch c or d increases or de-creases the level of the non fading. +6 6 isdisplayed as the level is increased ordecreased.Using the high pass filterWhen you do not want low sounds from thesubwoofer output frequency range to playfrom the front or rear speakers, turn the HPF(high pass filter) on. Only frequencies higherthan those in the selected range are outputfrom the front or rear speakers.Audio AdjustmentsEn66Section14
