Patton electronics SmartNode Series Software Configuration Manual

Also see for SmartNode Series: Software configuration guide Software configuration guide Software configuration guide Software configuration guide

Contents

Patton electronics SmartNode Series Software Configuration Manual Manual pdf 470 page image

ISDN Configuration Concept 470SmartWare Software Configuration Guide 36 • ISDN port configurationConfiguration exampleLet’s have a look at the configuration of a BRI port, running the network side of the DSS1 protocol. To thisISDN port a phone can be attached.1. port bri 0 12. clock auto3. encapsulation q9214. q9215. protocol pmp6. uni-side auto7. encapsulation q9318. q9319. protocol dss110. uni-side net11. encapsulation cc-isdn12. bind interface isdn01 switch13. port bri 0 114. no shutdownDescription1. Enter configuration mode for port bri 0/1.2. Clock mode is automatically determined by layer 2 UNI-side settings.3. Use ‘q921’ as layer 2 protocol.4. Enter Q921 mode.5. BRI uses point-to-multipoint topology.6. Layer 2 user/network setting is automatically determined by layer 3 UNI-side settings.7. Use ‘q931’ as layer 3 protocol.8. Enter Q931 mode.9. Layer 3 uses DSS1 signalling protocol.10. Running network side part of signalling protocol.11. Port 0/1 shall be bound to the call control.12. The call-control interface to use is ‘isdn01’.13. Enter configuration mode for port bri 0/1.14. Enable port.