Patton electronics IPLink Series Software Configuration Manual

Contents

Patton electronics IPLink Series Software Configuration Manual Manual pdf 135 page image

NAT/NAPT configuration task list 135IPLink Software Configuration Guide 12 • NAT/NAPT configurationActivate NAT/NAPTTo activate a NAT/NAPT component, bind its NAPT profile to an IP interface. This binding identifies theglobal interface of the respective NAT/NAPT component. All other IP interfaces are local relative to this NAT/NAPT.Note If both a NAPT profile and an ACL profile are bound to the same IP inter-face, the ACL (Access Control List) acts on the local side of the NAT/NAPT component.Procedure: To activate a NAT/NAPT componentMode: ConfigureExample: Configuring NAPT InterfaceThe following example shows how to activate a NAT/NAPT component with the NAPT profile access on theIP interface lan.IPLink(cfg)#context ip routerIPLink(ctx-ip)[router]#interface lanIPLink(if-ip)[lan]#use profile napt accessDisplaying NAT/NAPT configuration informationTwo commands are available to display an existing NAPT profile. There is no command yet to display thedynamic entries of a NAT/NAPT component.Procedure: To display NAT/NAPT configuration informationMode: ConfigureStep Command Purpose1 node(cfg)#context ip router Selects the IP router context2 node(ctx-ip)[router]#interfacenameThe NAPT profile shall be used on the interface name3 node(if-ip)[name]#use profilenapt profileDefines that the NAPT profile profile shall be used onthe interface nameStep Command Purpose1 node(cfg)#show profile napt Displays the available NAPT profiles2 node(cfg)#show profile naptnameornode(cfg)#show napt interfacenameDisplays the NAPT profile nameorDisplays the NAPT profile bound to the IP interfacename