Panasonic WV-SP105 Installation Manual

Also see for i-Pro WV-SP102: Integration note Product catalog Comparison chart Specifications Datasheet

Contents

Panasonic WV-SP105 Installation Manual Manual pdf 23 page image

23Before starting the connection, turn off the power of this camera and the devices to be connected.Check and prepare the required devices and cables for connection.Connection12V ININITIALSETACTLINK POWER10BASE-T/100BASE-TXLAN cable(This illustrationrepresents WV-SP105.)12V ININITIALSETACTLINK POWER10BASE-T/100BASE-TX(This illustrationrepresents WV-SP105.)To 12 V DCpower supply(12 V DC)(GND)12 V DC powercord plug(accessory)z Connect a LAN cable (category 5 or better) to thenetwork connector on the rear of the camera.x Connect the power cord.Important:• The 12 V DC power supply shall be insulated from the commercial AC power.● When using 12 V DC power supply*q Loosen the screw of the power cord plug (accessory).w Connect the cable of the 12 V DC power supply* to thepower cord plug.Strip 3 mm - 7 mm {1/8" to 9/32"} from the end of thewire, and twist the stripped part of the wire sufficiently toavoid short circuit.Specification of cable (wire): 16 AWG - 28 AWG,Single core, twisted• Check whether the stripped part of the wire is notexposed and is securely connected.e Tighten the screw of the power cord plug (accessory).r Connect the power cord plug (accessory) to the 12 V DCpower supply terminal on the rear of the camera.* FOR UL LISED MODEL(S), ONLY CONNECT 12 V DCCLASS 2 POWER SUPPLY.Caution:• FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY.