19.5 Configure the network settings of the camerausing the Panasonic “IP Setting Software”It is possible to perform the network settings of the camera using the “IP Setting Software” on the providedCD-ROM. When using multiple cameras, it is necessary to configure the network settings of each cameraindependently. If the Panasonic “IP Setting Software” does not work, access the “Network” page from the setupmenu of the camera in the browser and perform settings separately. (®page 151)IMPORTANT• The “Windows Security Alert” window may be displayed when starting the “IP Setting Software”. In thiscase, disable “User Account Control” from the control panel.• Panasonic “IP Setting Software” is inoperable in other subnets via the same router.• This camera cannot be displayed or set with an older version of the “IP Setting Software” (version 2.xx).• Due to security enhancements in “IP Setting Software”, “Network Settings” of the camera to beconfigured cannot be changed when around 20 minutes have passed after turning on the power of thecamera. (When the effective period is set to “20min” in the “Easy IP Setup accommodate period”.)However, settings can be changed after 20 minutes for cameras in the initial set mode.1. To start the Panasonic “IP Setting Software”, click the [Run] button next to [IP Setting Software] from theCD launcher menu window, or double-click on the shortcut icon created after installing the software on thePC.• The License Agreement will be displayed. Read the Agreement and choose “I accept the terms in thelicense agreement”, and click [OK].• The “IP Setting Software” screen is displayed. If a camera is found, information about it, such as theMAC address and IP address, is displayed.2. Click the [Access Camera] button after selecting the MAC address/IP address of the camera to beconfigured.Note• When using a DHCP server, the IP address assigned to the camera can be displayed by clickingthe [Search] button of the “IP Setting Software”.• When duplicate IP addresses are used, the number of the camera with the duplicate address isdisplayed in overlap.• The displayed camera information is not automatically updated. Click the [Search] button to updatethe information.• It is possible to change the “Camera list” display between IPv4 addresses and IPv6 addresses inaccordance with the protocol in use.208 Operating Instructions19 Using the CD-ROM
