Note• When the [Authentication] setting has been changed, close the web browser, and then access thecamera again.• For other devices such as network disk recorders, unless otherwise stated, Digest authentication isnot supported. (As of July, 2014)[User name]Enter a user name.• Available number of characters: 1 - 32 characters• Unavailable characters: " & : ; \• Default: None (blank)[Password] [Retype password]Enter a password.• Available number of characters: 4 - 32 characters• Unavailable characters: " &• Default: None (blank)Note• When the user name already in use is entered and the [Set] button is clicked, the respective userinformation will be overwritten.[Access level]Select the access level of the user from the following.• 1. Administrator: Allowed all available operations of the camera.• 2. Camera control: Allowed to display images from the camera and to control the camera. The camerasetting configuration is unavailable.• 3. Live only: Only displaying live images is available. The camera setting configuration and camera controlare unavailable.• Default: 3. Live only[User check]From the pull-down menu of “User check”, the registered user can be selected and the selected user’sinformation can be checked.The registered user will be displayed with the access level.(Example: admin [1])To delete the registered user, click the [Delete] button after selecting the user to be deleted.15.2 Configure the settings relating to the hostauthentication [Host auth.]Click the [Host auth.] tab on the “User mng.” page. (®page 41, page 43)Operating Instructions 14715 Configure the settings relating to the authentication [User mng.]
