Note• The settings for “Image capture size” of the “Alarm image” section on the [Alarm] tab (®page 87) willbe applied to the size of the image to be attached.Destination of notification[Address 1] - [Address 4]Enter the destination mail address. Up to 4 destination addresses can be registered.• [Alarm] checkbox: When the checkbox is checked, the mail notification will be performed upon an alarmoccurrence.• [Diag.] checkboxSW155SW152 : When the checkbox is checked, the mail notification will be providedin the following cases.– When notification of the remaining capacity of the SD memory card has been provided– When the SD memory card has become full– When the SD memory card cannot be recognized• [Destination address]: Enter the destination address.– Available number of characters: 3 - 128 charactersTo delete the registered address, click the [Delete] button respective to the desired address.[Mail subject]Enter the mail subject.• Available number of characters: 0 - 50 characters[Mail body]Enter the mail body.• Available number of characters: 0 - 200 charactersNoteSW155SW152:• Notification mail will be sent with the message “The capacity of the SD memory card is full.” when theSD memory card has become full, or “The SD memory card cannot be detected.” when mounting ofthe SD memory card failed.13.6 Configure the settings relating to Panasonicalarm protocol [Notification]Click the [Notification] tab on the “Alarm” page. (®page 32, page 34)Operating Instructions 9513 Configure the alarm settings [Alarm]
